Maintenance; Cleaning The Filter; Cleaning The Hood; Substitution Of The Led Bar - Sirius Satellite Radio SU107 Care And Use Manual

The range hood should provide many ye-
ars of trouble free use provided it is properly
maintained. Be sure the lights are cool before
cleaning the hood - they are halogen and be-
come extremely hot.

Cleaning the Filter.

The aluminium mesh filters should be wa-
shed by hand or in the dishwasher as requi-
red. Damaged and worn filters must be re-
placed immediately. (Do not operate blower
when filters have been removed). Allow filters
to dry before replacing them, otherwise water
will be drawn into the blower.
If a carbon filter has been fitted, this must be
replaced every 6 months as a minimum, de-
pending on usage and type of cooking that is
performed.
It is suggested that a spare set of carbon fil-
ters is kept on hand. These can be ordered
from the supplier of your range hood.

Cleaning the Hood

The outside and interior of your hood should
be wiped regularly with a clean, damp cloth
and mild household dish detergent or degre-
aser.
Use a good quality non-abrasive foaming
type stainless steel cleaner for exterior sur-
faces.
Follow the manufacturers directions. Gene-
rally the foam is sprayed onto a clean dry
cloth and then applied to the stainless steel.
Allow the foam to react on the surface for a
few minutes and then wipe with a clean dry
cloth.
On the surfaces that are exposed directly to
heat from the cook-top, it is advisable to cle-
an these regularly to avoid the deposits from
becoming baked on.
M A I N TE N A NCE
13
Do not use abrasive cleaning agents as the-
se will destroy the brushed finish.
Substitution of the LED bar SU107 :
Using an appropriate tool, remove the LED
bar from its seat (refer to Fig. 19), disconnect
it electronically using the appropriate con-
nector then substitute it with a LED bar with
same characteristics.
Replace the LED lamps SU82 :
To replace the round LED lamps (fig. 20) you
have to check first if it is possible to access
the back side of the lamp with your hand.
If it is possible to access the back side of the
lamp, you have to: insert your hand , push at
the same time both support wings of the
lamp, push to remove the lamp.
If it is not possible to access the back side of
the lamp, you have to: provide yourself with
a sharp utensil, insert the utensil between the
lamp and the stainless steel frame (on
the side where the little support wings are
placed), push to remove the lamp from the
cooker hood.