Cardinal Health NPWT PRO Quick Reference Manual

Cardinal Health™ PRO/PRO to GO
Negative Pressure Wound Therapy
Clinician Quick Reference Guide
ON/MUTE Button
Power / Charging Status
NOTE: Please refer to the Cardinal Health™ Negative Pressure Wound Therapy (NPWT)
PRO/PRO to GO Clinician User Manual for detailed instructions and review the Precautions
and Contraindications before use.
Insert Canister
Insert canister in holder by sliding it up into bottom of the Canister Holder. Line up the two short
ports with the Canister Holder and press until it "clicks" into place and locks. To remove canister,
press Canister Release Button, grasp canister at bottom and pull downward.
Connect the Dressing
Connect the blue end of the tubing to the open port of the canister. Gently twist and push
connector on just enough to seal it. Make sure that the clamp on the tubing is open.
NOTE: Please refer to the Cardinal Health™ NPWT PRO/PRO to GO Clinician User Manual for
instructions on how to properly dress the wound and troubleshoot issues.
Turning the PRO/PRO to GO ON
Press the ON button to start therapy. Select the desired Pressure Setting by pressing the
UP or DOWN arrow button. A green light begins flashing next to the selected Pressure
Setting. The light flashes and remains lit when the set pressure is reached. The light flashes if the
pressure cannot be maintained.
Therapy Lockout
To lock Therapy Setting, press and hold the ON
beeps three times indicating negative pressure wound Therapy Setting is locked. Repeat process
to unlock negative pressure wound Therapy Setting.
UP Button
Pressure Setting
DOWN Button
Alert Display
button for 3 seconds. The PRO/PRO to GO
Canister Release Button
OFF Button
Continuous / Intermittent Mode
Battery Charging Port
Canister Holder
Intermittent Mode
To operate the device in Intermittent Mode, press the Intermittent Mode
light indicates the PRO/PRO to GO is operating in Intermittent Mode. Repeat process to return to
Continuous Mode.
Adjust Alert Volume
Volume may be adjusted by pressing and holding the ON
or DOWN arrow button. The numbers 1 to 5 will appear in the Alert Display. The No. 1 is the
lowest; No. 5 is the highest volume level.
Troubleshooting
If the PRO/PRO to GO begins to alert, refer to the troubleshooting table on the back.
Turning the PRO/PRO to GO OFF
To turn PRO/PRO to GO off, press the OFF
The Alert Display flashes "o-f-f" three times while the PRO/PRO to GO is preparing to shut down.
For questions or information, contact Cardinal Health at 1.866.484.6798
Notice to Users: As with any prescription medical device, failure to
follow product instructions or adjusting settings and performing therapy
applications without the express direction and/or supervision of your
trained clinical caregiver may lead to improper product performance and
the potential for serious or fatal injury.
Defibrillation: Remove the wound dressing if defibrillation is required in
the area of dressing placement. Failure to remove the dressing may inhibit
electrical current transmission and/or patient resuscitation.
Button. An amber
Button and tapping the UP
Button.
Magnetic Resonance Imaging (MRI):
The PRO/PRO to GO is not MRI-compatible. Do not take into the MRI area.
Hyperbaric Oxygen Therapy (HBO): NEVER allow a device — whether
on or off — inside a hyperbaric chamber. The PRO/PRO to GO must be
disconnected from the patient prior to HBO treatment.