Extron electronics FOX3 Matrix 80x Setup Manual page 9

To edit the IP address:
1. Click on the Edit button (see figure 9,
Communication Settings box opens.
2. Click in the field to edit (see figure 11) .
3. Click Apply to complete and close.
Alternatively, click Apply and Connect to complete and connect to the
device.
Click Cancel to close the box without changes.
Internal Web Pages
Another way to configure and operate the switcher is via its factory-installed internal web pages. The pre-loaded web pages on
the switcher are accessible through the LAN port (see figure 2,
USB config port (see figure 6,
Disabling Compatibility Mode
The internal web page does not support compatibility mode in Microsoft Internet Explorer.
To check compatibility view settings:
From the Tools menu of the browser, select Compatibility View Settings. The Compatibility View Settings dialog box
1.
opens.
2. Be sure the Display all websites in Compatibility View checkbox is clear, and the IP address of the matrix is not in the
list of websites that have been added to Compatibility View.
Accessing the Internal Web Page
Access the FOX3 Matrix internal web page as follows:
1. Connect the FOX3 Matrix to a LAN or WAN using the rear panel RJ-45 LAN connector (see figure 2,
USB config port (see figure 6,
2.
Open a web browser on a connected PC.
3. Enter the FOX3 Matrix IP address in the browser Address field.
NOTES:
• If the local system administrators have not changed the value, the factory specified default for the LAN or WAN
connection is 192.168.254.254.
The default for the USB connection is 203.0.113.22 (this IP address cannot be changed).
•
4.
Press the <Enter> key on the keyboard.
5. The FOX3 Matrix is password protected. Enter a user name (user or admin) in the Username field and the password in the
Password field when prompted (see
NOTE: The factory configured passwords for all accounts on this device have been set to the device serial number. In
the event of a complete system reset, the passwords convert to the default. The default username is admin and the
password is extron.
3 on page 8). The
A on page 4) using a web browser such as Microsoft
A
on page 4).
figure 12 on page 10).
Figure 11.
C on page 2) via a LAN or WAN connection or the front panel
Internet Explorer
®
Communication Settings Box
.
®
C ) or the front panel
9