Advertisement
6. Insert the roller shaft into the right adjuster arm
and loosely secure it with a short bolt
14).
1. Roller
7. Install the bushing in the hole in the left
groomer-drive assembly
8. Thread the height-of-cut adjusting screw into the
top of the left adjuster-arm assembly
9. Insert the roller shaft into the left adjuster arm.
Note:
Do not tighten the bolt at this time.
10. Install the spring washer onto the rod end of the
left height-of-cut arm assembly
11. Install the left adjuster-arm assembly to the
cutting unit side plate using a plow bolt, nut, and
new washer
(Figure
Note:
Make sure that the rod end slides into
the bushing in the hole in the groomer drive
assembly.
12. Secure the adjuster-arm assembly rod end
to the groomer drive assembly with a locknut
(Figure
13).
(Figure
Figure 14
2. Short bolt
(Figure
13)
(Figure
(Figure
13).
13. Fill the gearbox cover with approximately 0.15
L (5 oz) of Mobil XHP-221 or equivalent and
mount it to the groomer housing assembly with
the gasket in between using 5 bolts
1
g030181
1. Bolt
13).
2. Gear-box cover
14. Center the roller between the adjuster arms and
tighten the mounting bolts
15. If you are installing the kit on a TriFlex 3300 or
13)
3400 machine, proceed to step 16. If you are
installing the kit on a walk-behind unit, perform
the following steps:
A. Install the belt-drive assembly to the cutting
B. Install the pulley to the reel shaft using the
C. Install the belt and tighten the belt-tensioning
D. Install the belt cover and tighten the captive
16. If you are installing the kit on a TriFlex 3300 or
3400 machine, install the motor mount to the
left end of the cutting unit using the 2 bolts that
you removed previously
7
3
2
Figure 15
3. Gasket
unit using the 3 bolts that you removed
previously
(Figure
6).
2 set screws that you removed previously
(Figure
5).
nut
(Figure
4).
bolt
(Figure
4).
(Figure
(Figure
15).
G018184
g018184
(Figure
14).
3).
Advertisement
