Replacing the Grooming
Reel
You can remove the grooming reel to replace
individual blades or the entire shaft. Remove and
replace the grooming reel shaft using the following
procedure:
1. Remove the gearbox cover from the groomer
housing
(Figure
26).
3
2
1
Figure 26
1. Bolt
2. Gearbox cover
3. Gasket
2. Loosen the bolt securing the roller shaft to the
height-of-cut arm
Figure 27
1. Roller
(Figure
27).
2. Roller-shaft bolt
3. Remove the locknut and Belleville washer
securing the height-of-cut arm assembly rod end
to the groomer drive assembly
1. Rod end of height of cut
assembly
2. Belleville washer
4. Remove the plow bolt, nut, and washer securing
the height-of-cut arm assembly to the side plate
G018184
(Figure
g018184
g030197
1. Adjuster-arm assembly
14
Figure 28
3. Locknut
29).
1
2
Figure 29
2. Washer and height-of-cut
nut
(Figure
28).
g010439
G018182
g018182