Advertisement
5. Remove the flange locknut securing the driven
gear to the end of the groomer shaft
Remove the gear.
1
G018183
Figure 30
1. Drive gear
2. Driven gear lock nut
3. Driven gear
6. Remove the groomer drive gear from the reel
shaft
(Figure
30).
7. Remove the 4 screws securing the groomer
drive assembly to the rear mounting plate
(Figure
31).
1
2
Figure 31
1. Groomer drive assembly
8. Remove the groomer shaft.
9. Torque the groomer drive gear to 170 N·m (125
ft-lb).
Note:
The use of an impact gun is not enough
to ensure proper installation. Failing to properly
(Figure
30).
5
4
3
2
g018183
4. Groomer shaft
5. Idler gears
G018940
g018940
2. Screw
torque the drive pulley can result in the assembly
unscrewing itself during operation.
15
Advertisement
