Advertisement
Installing the Gears and Groomer
Shaft
1. Secure the rear mounting plate using 2 shoulder
bolts as shown in
Note:
Make sure that the side plate rotates
freely.
2
1
1. Shoulder bolt
2. Put a light coating of grease on the O-ring and
the pilot bore
(Figure
1. Pilot bore
2. Drive assembly
Figure
8.
G018179
Figure 8
2. Rear mounting plate
9).
Figure 9
3. Screw
3. Secure the drive assembly to the rear mounting
plate with 4 screws
4. Apply grease to the seal in the drive assembly
bearing support and to the splined end of the
groomer shaft
1. Drive gear
2. Driven gear locknut
3. Driven gear
5. Install the spacer onto the splined end of the
groomer shaft.
6. Slide the splined end of the groomer shaft into
g018179
the drive-assembly-bearing support
7. Apply grease to the seal surface of the driven
gear, as shown in
1. Apply grease here.
8. Secure the gear to the groomer shaft with the
driven gear locknut
9. Torque the locknut to 23 to 28 N·m (17 to 21
ft-lb).
10. Apply grease to the seal in the left support-plate
bearing support and to the end of the groomer
shaft.
11. Insert the other end of the groomer shaft into the
G028141
left support plate
g028141
12. If you are installing the kit on a TriFlex 3300,
3320, 3400, or 3420 machine, proceed to step
13. If you are installing the kit on a walk-behind
unit, perform the following steps:
5
(Figure
9).
(Figure
10).
Figure 10
4. Spacer
5. Groomer shaft
6. Idler gears
(Figure
Figure
11.
Figure 11
(Figure
10).
(Figure
6).
g030169
10).
g030210
Advertisement
