Advertisement
Setting the Height/Depth of
the Groomer
The groomer blade height/depth can be set using the
following chart, figures, and procedure:
Number of rear-roller spacers
required
0
1
2
3
4
A
B
C
Figure 19
1. A = Low height-of-groom
range
2. B = High height-of-groom
range/Transport for A
range
Height of cut (HOC)
1.5 mm (0.06 inch)
3.0 mm (0.12 inch)
4.8 mm (0.19 inch)
6.4 mm (0.25 inch)
7.9 mm (0.31 inch)
9.7 mm (0.38 inch)
11.2 mm (0.44 inch)
12.7 mm (0.50 inch)
15.9 mm (0.625 inch)
19.1 mm (0.75 inch)
G027983
g027983
3. C = Transport for B range
(reduces clearance to the
grass basket)
Groomer-arm position
A
A
B
B
B
B
B
B
B
B
Note:
If you are using the groomer on an eFlex
traction unit, note that the groomer causes the unit to
drain the battery faster than without. The deeper you
set the groomer, the more power it will require and the
faster the battery charge will be depleted.
1. Make sure that the rollers are clean. Position
the machine on a flat, level work surface.
2. Using the above chart, determine the amount of
rear roller spacers required to attain the desired
grooming height/depth.
Note:
If installing 3 or 4 spacers on each side of
the rear roller, use the longer screws (included
in loose parts) instead of the standard screws.
3. Set the height of cut of the main reel.
4. Using the chart, determine the position required
to attain the desired grooming height/depth.
Raise or lower the grooming reel as follows:
A. Loosen the bolts on the right and left
groomer arms
10
Height of grooming range
(HOG)
0.8 to 1.5 mm (0.03 to 0.06 inch)
1.5 to 3.0 mm (0.06 to 0.12 inch)
2.3 to 4.8 mm (0.09 to 0.19 inch)
3.0 to 6.4 mm (0.12 to 0.25
inch)
3.8 to 7.9 mm (0.15 to 0.31 inch)
4.6 to 9.7 mm (0.18 to 0.38
inch)
5.3 to 11.2 mm
(0.21 to 0.44 inch)
6.4 to 12.7 mm (0.25 to
0.50 inch)
9.4 to 12.7 mm (0.37 to 0.50
inch)
12.7 to 15.7 mm (0.50 to 0.62
inch)
(Figure
20).
Advertisement
