Download Print this page
Avid Technology VENUE D-Show Manual
Avid Technology VENUE D-Show Manual

Avid Technology VENUE D-Show Manual

Hard drive for venue foh rack

Advertisement

Quick Links

VENUE D-Show Hard Drive
For VENUE FOH Rack
Replacing a Hard Drive
The following procedure outlines the steps for removing and
replacing the hard drive in the VENUE FOH Rack.
VENUE FOH Rack hard drive
If you are using a power screwdriver be sure to use the low-
est torque setting to prevent damage to screws or inserts.
To remove the FOH Rack Hard Drive:
Power down the FOH Rack and disconnect all power, audio
1
and cables from the unit.
Using a #1 Phillips screwdriver, remove the 4 type P (M3 x 6
2
flat head) screws that secure the hard drive bay to the FOH
Rack.
Removing the hard drive bay from the FOH Rack
Slide out the hard drive bay from the FOH Rack.
3
Sliding the hard drive bay from the FOH Rack
The IDE cable and the 4-pin power cable are hot-glued in
4
place. Use a small flat blade screwdriver or X-acto knife to
carefully remove the bead of glue holding each connector in
place.
Disconnect the IDE cable and power cable, while taking
5
note of the cable plug orientation for each cable.
Disconnecting cables from the hard drive
VENUE D-Show Hard Drive 1

Advertisement

loading
Need help?

Need help?

Do you have a question about the VENUE D-Show and is the answer not in the manual?

Questions and answers

Summary of Contents for Avid Technology VENUE D-Show

  • Page 1 FOH Rack. Disconnecting cables from the hard drive Removing the hard drive bay from the FOH Rack VENUE D-Show Hard Drive 1...
  • Page 2 See the VENUE D-Show Guide for more information. Legal Notices This guide is copyrighted ©2010 by Avid Technology, Inc., (hereafter “Avid”), with all rights reserved. Under copyright laws, this guide may not be duplicated in whole or in part without the written consent of Avid.