Avid Technology S6L Control Surface Replacement
Cmos battery replacement
Hide thumbs
Also See for S6L Control Surface:
- Replacing (31 pages) ,
- Installing (18 pages) ,
- Replacing (13 pages)
Table of Contents
Advertisement
Quick Links
S6L Control Surface CMOS Battery Replacement
This document provides instructions for replacing the CMOS battery in the S6L control surface. It is recommended to replace the
battery if your S6L control surface has been in use for three years or more.
Images shown in this guide (such as cable colors or hardware configuration) may not exactly match your S6L.
Required Materials
Be sure to gather the following before proceeding:
• Replacement CMOS battery (available from any source that sells standard watch batteries).
Type: CR2032 3V Lithium Coin Cell Battery
• Anti-Static wrist strap (not included)
• Access to the back of the S6L control surface and enough room to remove the back cover.
S6L Control Surface CMOS Battery Replacement
9329-66217-00 REV A
1
© 2021 Avid Technology, Inc
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Avid Technology S6L Control Surface
Summary of Contents for Avid Technology S6L Control Surface
- Page 1 S6L Control Surface CMOS Battery Replacement This document provides instructions for replacing the CMOS battery in the S6L control surface. It is recommended to replace the battery if your S6L control surface has been in use for three years or more.
- Page 2 Prepare the S6L Control Surface Prepare the S6L control surface by removing the lower and upper back covers. The steps required to remove the back cover vary depending on the model of S6L control surface. S6L-24D, S6L-32D, S6L-48D To remove the lower back cover from S6L-24D, 32D, or 48D: Using a 2.5mm Hex driver, remove the fasteners that secure the back cover to the S6L chassis and set the screws aside.
- Page 3 (or both) of the End Caps completely, carefully disconnect the LED power cable before moving the cap away from the chassis. Fasteners: M4x8mm BHCS Tool: 2.5mm Hex driver Figure 4. End Cap fasteners S6L Control Surface CMOS Battery Replacement...
- Page 4 After removing the fasteners try sliding the back cover off the chassis by pushing it down with your hands and simultaneously pulling the cover away from the chassis. Slide the panel away from the control surface, and set the panel aside. S6L Control Surface CMOS Battery Replacement...
- Page 5 Carefully lift the top cover off the chassis and set it face down on the towel you placed on the surface, being careful to not stretch or stress the cables connected to the light sockets. Proceed to Replace the CMOS Battery S6L Control Surface CMOS Battery Replacement...
- Page 6 To install a new CMOS battery: Being sure to orient the battery correctly, carefully insert the battery into its slot until it seats fully and its retaining clips latch. Proceed to Complete the Installation S6L Control Surface CMOS Battery Replacement...
- Page 7 • The System LED begins to flash amber while the E6L is waiting to connect to the S6L control surface. Power on the S6L control surface by pressing the power switch on the back panel to the on (1) position. The System LED turns green when connection is complete.
- Page 8 On touch screens, touch in a field and slide your finger up or down on the screen to increase or decrease the value in the field. Select each available field and enter the appropriate data to set the time and date. Select Apply. The new System Clock settings are applied. Your S6L control surface is now ready for use. S6L Control Surface CMOS Battery Replacement...
Need help?
Do you have a question about the S6L Control Surface and is the answer not in the manual?
Questions and answers