Stryker THC5 Assembly Instructions

THC5 (11225) Assembly instructions
Items needed
• (1) THC5, stand assembly (p/n 11225)
• (1) Instruction sheet (p/n 0000-001-023)
Tools required
• 7/16" Wrench
• Torque wrench
Procedure
To assemble the THC5 pole
1. Insert the pin located on the end of the pole, into the guide pin hole on the base
page 1).
Figure 1: Pin
2. Tip the stand over and insert the provided screw and washer into the bottom of the base
Figure 3: Bottom of the base
3. Using a 7/16" wrench and torque wrench (20.5 ± 3 ft-lb), tighten the screw and washer.
4. Turn the stand over and make sure the pole is secure to the stand
www.stryker.com
Figure 4: THC5 assembly
(Figure 4 on page
0000-001-023 REV C
(Figure 1 on page 1 and Figure 2 on
Figure 2: Base
(Figure 3 on page 1).
1).
1