Tanco S100 A Quick Reference Manual

S100 A QUICK REFERENCE GUIDE

The quick reference guide is not a substitute for the Operators Manual!

Please refer to Operators Manual for more detailed information

TRACTOR CONNECTION

1. Hydraulics

Red pipe

> Supply (35-40lpm)

Blue pipe

> Return (Free flow return!!)

2. Electrics

A. Connect 12V supply to 3pin plug

B. Connect wrapper harness to controller

1. Remove the wrap arm transport lock.

2. Position the safety arms into the working

position by removing the retaining pin.

3. Adjust the load arm stop pin to allow

clearance between the top of the bale at the

rotating arm.

4. Install the roll of film and attach the film to

the Cut & Start.

Table of Contents

Do you have a question about the S100 A and is the answer not in the manual?

Page 1 S100 A QUICK REFERENCE GUIDE The quick reference guide is not a substitute for the Operators Manual! Please refer to Operators Manual for more detailed information TRACTOR CONNECTION 1. Hydraulics Red pipe > Supply (35-40lpm) Blue pipe > Return (Free flow return!!) 2.
Page 2 OPERATION Auto mode (A) Activate the “Rollers out” (a) function to open the rollers Drive into the bale until the bale contacts the bale support roller. Activate “Rollers in” (b) to load the bale. Once the bale is loaded, pressing “Auto start”...
Page 3 EXPERT CONTROLLER OPERATION - Current No. of wraps - Set No. of wraps - Target No. of wraps - Change / reset bale sub-total - Wrapping speed (RPM) - Access Operator Menu - Bale total - Access Technician Menu - Grand total No. of bales - Mode: Manual /Auto Add extra wrap Pause wrapping...
Page 4 OPTIONAL HANDHELD REMOTE The operator can activate the main wrapper functions through the handheld remote. This means that the operator can hold the remote in their hand while operating the tractor. Auto mode Auto mode Rollers out Rollers in Auto mode Auto start wrap ENTERING THE TRANSPORT POSITION 1.