Crestron Avia Dsp Configuration; Connections; Device Discovery/Access; Set Up Sip Interface - Crestron Avia DSP Series Configuration Manual

Crestron Avia DSP Configuration

This section provides the following details:
How to set up connections to the amplifier and speaker
l
How to access the DSP on the network (once powered)
l
How to configure the DSP for registration and integration with the PBX
l

Connections

Make the following connections:
Connect microphone to DSP MIC/LINE INPUTS port 1
l
Connect DSP LINE OUTPUTS port 1 to "Audio In" on amplifier
l
Connect "Audio Out" of amplifier to speaker
l
Connect LAN port to network
l

Device Discovery/Access

Use the Crestron Toolbox and the Crestron Avia tool to discover and access the connected
LAN and/or VOIP ports) DSP devices.
Use the Help menu to assist when performing the discovery and configuration procedure.

Set Up SIP Interface

The DSP units have separate network interfaces for Voice over Internet Protocol (VoIP)
and LAN on the rear panel. Configure either one for SIP calling. The default configuration
binds SIP calling to the LAN interface. An optional console command binds the SIP
interface to the VoIP connector. Configure all VoIP connections on a separate Virtual Local
Area Network (VLAN) or subnet. VoIP connections cannot be on the same subnet as the
LAN connection.
Ethernet
Use the Ethernet command to turn the VoIP port on/off.
DSP-1281>Ethernet ?
ETHERNET [<device_num> ON | OFF [/now]]
Device_num - 0 nn
ON - enables VoI
OFF - disables VoIP
/now - take effect without a reboot
No parameter - displays the current setting
Configuration Guide — 8340B DSP-1282 & DSP-1283: Secure SIP Endpoint with Avaya Aura 7.1 • 5