Faults - WIKA KSR KUEBLER BGU D Series Operating Instructions Manual

6

Faults

Fault
Bypass magnetic
switch cannot be
attached in the
place intended
No signal or in-
correct signal
50
The most frequent causes for faults and the counter-
measures necessary are listed in the tables below.
Cause
Collision with other attach-
ments
Electrical connection incor-
rect
Reed contact defective
incorrect switching behav-
iour
Switch position incorrect
Cable ripped off
Switch is not triggered by
float
CAUTION!
Bodily injuries, property and environmental damages
If faults cannot be remedied with the help of the measures
listed above immediately decommission the device.

Ensure that there is no more pressure and protect
against accidental commissioning.

Contact the manufacturer.

In the event a return is necessary note the instruc-
tions in Section 8.2 "Return".
KSR KUEBLER Operating instructions Bypass magnetic switch - BGU-...D
Measure
Reconstruction of the at-
tachments or return to fac-
tory
See Section 5.4 "Electrical
Connection".
Check configuration with
the help of the circuit dia-
gram.
Return to factory
Change terminal configura-
tion
Re-position BGU
Return to factory
Return to factory