Typical Examples For Configuring Pppoe - H3C SecPath F1800-A Operation Manual

Operation Manual - Link Layer Protocol
H3C SecPath F1800-A Firewall
View the status and statistics of the
PPPoE session.
Debug the PPPoE client.

3.5 Typical Examples for Configuring PPPoE

I. Configuration Requirements
The hosts access the Internet through the SecPath F1800-A by making use of
PPPoE.
II. Networking Diagram
The SecPath F1800-A is connected to the Ethernet through Ethernet 1/0/0 and the
Internet through Ethernet 3/0/0.
Host
Host
Figure 3-2 PPPoE networking diagram
III. Configuration Procedure
# Add a PPPoE user.
[SecPath-aaa] local-user testuser password simple testpwd
# Set PPPoE parameters on the SecPath F1800-A.
[SecPath] interface ethernet 1/0/0
[SecPath-Ethernet1/0/0] pppoe-server bind virtual-template 1
# Set virtual template parameters on the SecPath F1800-A.
[SecPath] interface virtual-template 1
[SecPath-Virtual-Template1] ppp authentication-mode chap
[SecPath-Virtual-Template1] remote address pool 1
[SecPath-Virtual-Template1] ip address 1.1.1.1 255.0.0.0
# Add a local IP address pool that contains nine IP addresses.
[SecPath] ip pool 1 1.1.1.2 1.1.1.10
Action
Ethernet1/0/0 Ethernet3/0/0
SecPath
4-27
Chapter 3 PPPoE Configuration
Command
display pppoe-client session { summary
| packet } [ dial-bundle-number number ]
debugging pppoe-client option [ interface
type number ]
Internet