Husqvarna K 7000 Ring Operator's Manual page 25

4. Pull out the guide roller from the product.
5. Install the knob and tighten it fully. Then loosen the
knob 2 turns.
6. Install the new guide roller in the product.
7. Lubricate the guide rollers. Refer to
guide rollers on page 24 .
8. Install the cutting blade and the support roller guard.
To install the cutting blade on page 12 .
Refer to
To replace the support rollers
The support rollers must be examined 2 times during the
life of the cutting blade. Do a check after the installation
of the cutting blade and when the cutting blade starts to
become worn. Replace the support rollers when the
1461 - 001 - 17.02.2020
surface is flat. The illustration shows a new support
roller (A) and a worn support roller (B).
1. Remove the support roller guard.
2. Remove the support rollers with the 19 mm open
To lubricate the
wrench and the 13 mm combination wrench.
25