Advertisement
Note: Applies to all drawer and suspended cabinet configurations.
It is best to install drawer bracket and drawer(s) while bench in upside down.
Step 1:
Install rear mounting bracket to worksurface as shown on below using hardware listed above.
Note: The position of your bracket will be determined by the size of your front beam. Remove drawer from
drawer case by pulling the drawer body out of the case. Locate the slide release tabs. Lift up on the left side
tab and press down on the right side tab and pull on drawer body.
Step 2: Install the captive retainer nuts onto the bench front beam as shown below.
Step 3: Finish the drawer assembly as shown below using ¼-20 X 1.00 HH bolts and ¼ flat black washer
(items A & B) for the connection of the support beam and drawer case. Using items (F & B) for the connection
of the back of the drawer case and the drawer hanger bracket (H).
STEP #1
STEP #2
4
STEP #3
STEP #3
Advertisement
