Install The Rails In The Cabinet; Install The Base Enclosure On The Rails - Dell EMC PowerStore T Installation And Service Manual

Install the rails in the cabinet

This task describes the procedure to install one rail. After installing one rail, repeat the procedure for the other rail. The procedure is the
same for both the left and right rail. You can install the rails into either a square or round hole rack.
Steps
1. Position the rail end piece so the label FRONT is located at the front of the rack and facing towards the inside of the rack, while
orienting the rear of the rail to align level with the holes on the rear of the rack.
2. From the rear of the rack, pull the rail straight back until the latch is locked.
3. To install the front end piece of the rail, press the blue latch release button until the latch rotates open.
4. Pull the rail forward until the pins slide into the holes on the front of the rack, then release the latch to secure the rail in place.
Figure 1. Installing the rails
5. Repeat for the other rail.

Install the base enclosure on the rails

About this task
CAUTION:
The enclosure is heavy and should be installed into or removed from a rack by two people. To avoid personal injury
and/or damage to the equipment, do not attempt to lift and install the enclosure into a rack without a mechanical lift
and/or help from another person.
L'enclosure étant lourde, sa mise en place dans l'armoire nécessite deux personnes. Afin de ne pas vous blesser et/ou
endommager le matériel, n'essayez pas de soulever et d'installer l'armoire sur une rampe sans avoir recours à un
relevage mécanique et/ou à l'aide d'une autre personne.
Das Gehäuse ist schwer und sollte nur von zwei Personen in einem Rack installiert werden. Zur Vermeidung von
körperlichen Verletzungen und/oder der Beschädigung des Gerätes, bitte das Gehäuse nicht ohne die Hilfe einer
zweiten Person anheben und einbauen.
Il contenitore è pesante e dev'essere installato nel rack da due persone. Per evitare danni personali e/o
all'apparecchiatura, non tentare di sollevare ed installare in un rack il contenitore senza un sollevatore meccanico e/o
l'aiuto di un'altra persona.
10 Install a new base enclosure and optional expansion enclosure