LG PAHCMR000 Installation Manual page 10

COMMUNICATION KIT
10
Connection of the wires
1
For connection to outdoor unit and to controller (Field supply) :
Pull the wires inside through the cable gland and close the nut firmly in order to ensure a
good pull relieve and water protection.
2
The wires require an additional pull-relief. Strap the wire with the support tie wrap.
3
For the wired remote controller wire and outdoor unit communication wire, use the Pin type
(JOBN153) to connect to the terminal block.
CAUTION
!
• All field supplied parts and materials and electric works must be conform to local codes.
• Use copper wire only.
• All wiring must be performed by an authorized electrician.
• A main switch or other means for disconnection, having a contact separation in all poles,
must be incorporated in the fixed wiring in accordance to relevant local and national
legislation.
• Refer to the installation manual attached to the outdoor unit for the size of power supply
electric wire connected to the outdoor unit, the capacity of the circuit breaker and switch,
wiring and wiring instructions.
Pin type (JOBN153)