Pre-Maintenance Procedures; Preparing For The Machine For Maintenance; Accessing The Console Compartment - Toro 29519 Operator's Manual

Maintenance Service
Interval
Every 250 hours
Every 500 hours
Every 800 hours
Yearly
Yearly or before storage
Pre-Maintenance
Procedures
CAUTION
Raising the machine for service or
maintenance relying solely on mechanical
or hydraulic jacks could be dangerous. The
mechanical or hydraulic jacks may not be
enough support or may malfunction allowing
the machine to fall, which could cause injury.
Do not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands
or equivalent support.
Preparing for the Machine
for Maintenance
Perform the following before servicing, cleaning, or
making any adjustments to the machine.
1. Park the machine on a level surface.
2. Shut off the engine, engage the parking brake,
wait for all moving parts to stop.
3. Remove the key from the key switch.
Maintenance Procedure
• Replace the primary air-cleaner element (more often in extremely dusty or sandy
conditions).
• Check the secondary air-cleaner element (more often in extremely dusty or sandy
conditions).
• Change the auxiliary hydraulic reservoir filter and fluid.
• Change the transmission filters.
• Fill the transmission with fluid when changing the filter.
• Replace the secondary air-cleaner element (more often in extremely dusty or sandy
conditions).
• Replace the fuel filter.
• Grease the front caster pivots.
• Grease the belt idler pivot.
• Grease the caster pivots and hubs.
• Lubricate the caster-wheel hubs.
• Lubricate the caster-wheel hubs.
• Check the torque of the wheel hub nuts.
• Check the torque on the wheel lug nuts.
• Check the torque of the transmission output shaft nut.
• Touch up areas with chipped paint.
Accessing the Console
Compartment
Removing the Console Pad
1. Loosen the 4 flanged-head bolts that secure the
pad to the left and right console panels
24).
1. Keyhole slot (console
panel)
2. Fanged-head bolt
2. Lift up the console pad
13 mm (1/2 inch).
3. Pull the console pad straight back and remove
the pad from the machine
28
Figure 24
3. Pad
(Figure 24) approximately
(Figure 24).
(Figure
g025880