Table of Contents
Advertisement
4
Servicing the Transmission
Fluid
No Parts Required
Procedure
Transmission fluid type: Toro Hypr-oil 500
The machine is shipped with hydraulic fluid in the
expansion tank.
1.
Run the machine for approximately 15 minutes
to purge any extra air out of the hydraulic
system.
2.
Shut off the engine and allow the machine to
cool.
3.
Check the hydraulic-fluid level in the expansion
tank
(Figure
5).
Note:
The transmission-fluid level should cover
the Full Cold line molded into the side of the
tank.
1. Cap
2. Filler neck (expansion
tank)
4.
If necessary, add the specified transmission fluid
until the fluid level is at the Full Cold line of the
expansion tank
(Figure
5.
Install the cap onto the expansion tank and
tighten the cap until it is snug.
Note:
Do not overtighten expansion-tank
cap.
Figure 5
3. Full Cold line
5).
5
Servicing the Auxiliary
Hydraulic Fluid
No Parts Required
Procedure
Hydraulic fluid type: AW-32 hydraulic fluid
Note:
The machine is shipped with hydraulic fluid
in the reservoir.
1.
Run the machine for approximately 15 minutes
to purge any extra air out of the hydraulic
system.
2.
Completely raise and lower the tines 3 times to
purge the air.
3.
Shut off the engine and allow the machine to
cool.
4.
Loosen the 4 bolts inside the frame securing the
pad to the machine.
5.
Lift the pad up and back to remove it
g025891
6.
Remove the cap and check the hydraulic-fluid
level in the reservoir
Note:
The hydraulic-fluid level should cover the
word Cold that is embossed into the baffle of
the reservoir.
14
(Figure
Figure 6
(Figure
7).
6).
g018375
Advertisement
Table of Contents
