Product Overview; Controls - Toro 29519 Operator's Manual

Figure 7
1. Cold fluid level
7. If necessary, add the specified hydraulic fluid to
the reservoir until the fluid covers the Cold fluid
level on the baffle
Note:
The baffle in the reservoir is labeled Hot
and Cold. Fill the reservoir to the appropriate
level depending upon the temperature of the
fluid. The fluid level varies with the temperature
of the fluid. The Cold level shows the level of
the fluid when it is at 24°C (75°F). The Hot
level shows the level of fluid when it is at 107°C
(225°F).
For example: If the fluid is at ambient-air
temperature, about 24°C (75°F), fill only to the
Cold level. If the fluid is about 65°C (150°F), fill
to halfway between the Hot and Cold levels.
8. Replace the hydraulic reservoir cap and tighten
it until snug (Figure
Note:
Do not overtighten the reservoir cap.
9. Install the pad that you removed in steps
5 top the frame, and tighten the 4 bolts to 1978
to 2542 N∙cm (175 to 225 in-lb).
2. Hot fluid level
(Figure 7).
7).

Product Overview

g025893
1. Platform
2. Parking-brake knob
3. Motion-control levers

Controls

Motion-Control Levers
The motion-control levers are located on each side of
the top console and control the forward and reverse
motion of the machine.
Move the levers forward or backward to control the
drive wheel on the same side forward or reverse
respectively. The wheel speed is proportional to the
amount you move the lever.
4 and
Important:
motion-control levers are moved out of the
N position.
EUTRAL
15
Figure 8
4. Engine controls
5. Fuel cap
The tines rotate when the
g020220