Table of Contents
Advertisement
1. O
position
FF
Specifications
Height
Length
Width
Aeration width
Coring range
Weight
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro
delivers replacement parts designed to the exact
engineering specification of our equipment. For peace
of mind, insist on Toro genuine parts.
Figure 12
2. O
position
N
132 cm (52 inches)
163 cm (64 inches)
121 cm (48 inches)
76 cm (30 inches)
5.1 to 12.7 cm (2 to 5 inches)
460 kg (1,015 lb)
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Checking the Engine-Oil
Level
Service Interval: Before each use or daily
Oil Type: Detergent oil (API service SJ or higher)
Oil viscosity: Refer to the table below.
g025897
Important:
Do not operate the engine with the oil
level below the Low (or Add) mark on the dipstick,
or over the Full mark.
1.
Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
2.
Allow the engine to cool.
3.
Check the engine-oil level as shown in
14.
18
Figure 13
g004216
Figure
Advertisement
Table of Contents
