DataRemote Pots In a Box CDS-9090 User Manual page 22

PHASE 4
Testing Fire Alarm communication over
DataRemote's CDS-9090 device.
4. Fire Alarm Panel confirmation:
- Walk back to the Fire Alarm Panel to verify that the panel cleared the trouble condition.
- If both test calls above completed successfully and the trouble condition cleared, then proceed to
call alarm vendor next.
- If testing was unsuccessful on either line, then:
Verify the DataRemote CDS-9090 device phone ports are still providing dial-tone and
allowing outbound calls to be made. If not working, then contact Install Support
Verify cabling connections to/from Fire Alarm Panel/DataRemote CDS-9090 device.
Call Install Support Team to assist in troubleshooting
5. Call fire alarm vendor to confirm they show the error and that it has been cleared:
- Have New DataRemote CDS-9090 device TN's recorded in your checklist handy to give to alarm
vendor when calling, as well as store name and location # (number)
- Confirm the fire alarm vendor is receiving The New DataRemote CDS-9090 device phone 1-8
(respectively) telephone numbers recorded in your checklist against the respective primary &
secondary line trouble calls they received/logged in their monitoring system.
6. Call Install Verification line to confirm that communication through the DataRemote CDS-9090
device was successful.
7. Cleanup area, dress any cables needed then take photos of installation as required in below
deliverables section.
8. Confirm the phone 1-8 LEDs (respectively) are all solid green (if blinking, it may be making a call so
just wait for it to go solid again). Lights should be as below; capture picture of their status
(REQUIRED, SEE AN EXAMPLE BELOW):
(continued)
Revision No. 004 April 2020
Page 22