Commissioning The Interconnection Between The Device And The Router - Huawei UA5000 Commissioning Manual

UA5000 Universal Access Unit Product
Commissioning Guide-PVM CLI
Media IP
Transfer Mode
Primary Proxy IP 1
Primary Proxy IP 2
Primary Proxy Port
Secondary Proxy IP 1
Secondary Proxy IP 2
Secondary Proxy Port
Proxy address mode
SIPProfile Index
Primary Proxy Domain Name
Secondary Proxy Domain Name -
Home Domain Name
Description
MG Domain Name
Phone Context
Register URI
Conference Factory URI
------------------------------------------------------------
Step 5 Reset the SIP interface.
huawei(config-if-sip-0)#reset
huawei(config-if-sip-0)#quit
Step 6 Save the data.
huawei(config)#save
----End
Result
After the display if-sip attribute command is executed to query the current attributes of the SIP
interface, it is found that the attributes of the SIP interface are the same as the configured
attributes.
4.4 Commissioning the Interconnection Between the Device
and the Router
This topic describes how to check whether the UA5000 can normally communicate with the
router and whether the UA5000 can access the upper-layer device through the router.
Service Requirements
In the network as shown in
transmission.
Issue 04 (2012-06-25)
NOTE
For details about how to configure a router, see the related configuration guide.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10.13.4.116
UDP
10.13.4.110
-
5555
10.13.4.120
-
5555
IP
1:profile2
-
UA5000.com
-
huawei.com
+86755
-
-
Figure 4-6, the UA5000 uses the PVMB board for upstream
4 Commissioning the Interconnection
106