Voip And Pots Phone Installation - Globalstar Sat-Fi2 User Manual

VOIP AND POTS PHONE INSTALLATION

NOTE: The following steps must be completed in the proper order. DO NOT power on any device until instructed to do so in
the steps below.
Install the Sat-Fi2 Remote Antenna Station (RAS) in
1
accordance with the Sat-Fi2 Remote Antenna Station
Quick Installation Guide and perform the following:
• Power on the RAS - The Power On sequence can
take up to 5 minutes.
• Once the Power and Satellite LEDs are blinking in
unison, proceed to Step 2.
2
Connect an Ethernet Cable to the RAS Ethernet Port.
Connect the other end of the Ethernet Cable to Port 1 on
3
the 5-Port Switch.
4
Connect an Ethernet Cable to Port 2 on the 5-Port Switch.
5
Connect the other end of the Ethernet cable to the
Internet Port on the Cisco VoIP Router.
6
Connect an RJ11 Cable to the Phone 1 Port on the
CiscoVoIP Router.
Sat-Fi2 RAS
SOS SOS
2
12VDC 12VDC
POTS Phone
1 2 1 2 3 3
4 5 4 5 6 6
7 8 7 9 8 9
0 # 0 #
FLASH REDIAL FLASH REDIAL SOS SOS
Sat-Fi2 Desktop App User Guide
Power LED
1
7
7 Connect the other end of the RJ11 Cable to the POTS
Phone.
For the 5-Port Swtich, perform the following:
8
•
•
For the Cisco VoIP Router perform the following:
9
•
•
•
10 When the Cisco VoIP Router Phone 1 LED turns to a
steady Green, the POTS Phone is operational.
Satellite LED S.O.S. LED
SOS SOS
Power Switch
Phone 1 LED
10
Connect the Power Cord into the Power port of the
5-Port Switch.
Connect the Power Cord to an AC Power
source. Wait 30 seconds for power and ethernet
connectivity.
Connect the Power Cord into the Power port of the
Cisco VoIP Router.
Connect the Power Cord to an AC Power source.
Boot time may take up to 2 minutes.
5-Port Switch
LINKSYS LINKSYS
5-PORT GIGABIT SWTICH 5-PORT GIGABIT SWTICH LINK/ACT/GB LINK/ACT/GB
SE3005 SE3005
SYSTEM SYSTEM
1 1 2 2 3 3 4 4 5
4
3
Cisco VoIP Router
RESET RESET PHONE 1 PHONE 1 PHONE 2 PHONE 2 INTERNET INTERNET
6 5
5
5-Port Switch
8
Power Cord
DC 5V DC 5V Cisco VoIP Router
POWER POWER
Power Cord
9
Page 6