Operating Instructions - Wahl LITHIUM PRO Series Instructions Manual

LITHIUM PRO SERIES CLIPPER

OPERATING INSTRUCTIONS

CHARGING THE BATTERY
Before the appliance is used for the first time, it should
be charged for 5 hours, you will need to plug the
transformer directly into the unit but be sure the clipper
is switched OFF when charging. When the battery is
fully charged, the equipment can be used for up to 120
minutes continuous run time. It will then take 3 hours to
fully recharge the battery again.
CHARGING PRECAUTIONS
• Only charge the device when charging is required.
A charge is required when the product begins to
slow down or has trouble maintaining speed while
performing its intended function. (Note: If the product
is cord/cordless, and you do run out of charge, you
may continue running the device corded from the
mains to complete your task.)
• If the device is fully discharged, apply a charge right
away to prevent damage or inability to recharge.
• A partial charge is fine; Lithium-Ion does not require a
full charge.
• Charge the device at moderate temperatures. Do not
charge below freezing.
• Do not leave the device connected to the charger
when the charger is not plugged into an outlet for
charging.
• Perform regular maintenance on the device including
keeping the blades oiled, clean, and free of debris to
prevent taxing the battery.
8