Table of Contents
Advertisement
LITHIUM PRO SERIES CLIPPER
TROUBLESHOOTING
If your clipper does not seem to take a charge, check
the following before returning it for repair:
• Check outlet to make sure it is working by plugging in
another appliance.
• Be sure the clipper is properly connected to the
recharging transformer, all connections are secure
and the switch on the clipper is turned OFF.
• If your electricity is connected to a master power
switch, we suggest the clipper be disconnected from
the charger anytime the master switch is off. Leaving
the unit plugged into a dead outlet or an unplugged
charger will drain the battery.
• If the clipper does not run and is completely charged,
turn the unit ON and pinch or push the blades
manually. (Oil may have dried out between the
blades, so they may be temporarily stuck together.)
LITHIUM-ION BATTERY REPLACEMENT REMOVAL
AND DISPOSAL
For battery replacement the entire, intact clipper or
trimmer should be sent to: Wahl (UK) Ltd Customer
Services (the address can be found on the reverse of
this booklet) or taken to a suitably qualified professional.
The battery should only be replaced by the original
manufacturers spare, for safety reasons a substitute
should not be used.
Do not attempt to remove the battery. Lithium-Ion
batteries can explode, catch fire, and/or cause burns
if disassembled, damaged or exposed to water or high
temperatures.
14
Hide quick links:
Advertisement
Table of Contents
