Wahl LITHIUM PRO Series Instructions Manual page 9

FOR DIRECT PLUG-IN OPERATION
1. Should you need to use the appliance in corded
mode when the battery is fully discharged, it is best
to charge the appliance in OFF position for several
minutes before use. During use, you may notice
a change in blade speed. This is perfectly normal.
The clipper will still perform adequately in corded
mode with fully discharged batteries.
2. Connect the appliance to the transformer cord, and
plug the wall transformer into an electrical outlet.
3. Move the switch to ON position.
4. After use, turn to OFF position then disconnect wall
transformer from outlet.
BLADES
• Blades do not become dull from cutting hair, they
are dulled by abrasive particles on the hair, such as
dirt, sand and grease etc.
• Blades will not cut if abrasive particles are picked
up and carried by the oil film between the blades.
These particles tend to hold the blades apart and
cause chewing and pulling of the hair instead of
clean cutting.
• The cutting blades furnished with Wahl Animal
clippers are made of special high carbon steel
scientifically heat-treated for correct hardness.
Years of experience have created a special process
for grinding these blades to a superior sharpness.
Oil blades before and during use.
• Oiling the blades performs two distinct functions.
a. Provides a low friction, very thin film lubricant
between the cutting blades so that they can take a
LITHIUM PRO SERIES CLIPPER
9