Replace The Rope - Horn Tools HPA Series User Manual

1. Place the clutch on the „OUT" position
2. Take off the rope unit to its full length. You can now see how the existing rope is connected to the drum.
3. Remove the old rope unit and attach a new unit to the drum in the same way.
4. Make sure the new rope is wound up in the same direction as the old rope. The rope should leave the
drum from the bottom, under the drum.
5. Place the clutch on the "IN" position
6. Wrap the rope unit on the drum. On the first five revolutions be careful not to buckle the rope. Then the
rope must be wrapped under a load of at least 5% of the nominal pull force on the drum.
WARNING - swap the rope only with the identical spare parts recommended by the manufacturer.
16

REPLACE THE ROPE