Troubleshooting - Zanussi ZOA35660XK User Manual

Step 1
Turn off the oven. Wait until the
oven is cold.
Back lamp
Step 1 Turn the glass cover to remove it.
Step 2 Clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Install the glass cover.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
WHAT TO DO IF...
Problem
You cannot activate or operate
the oven. The display shows
"400" and an acoustic signal
sounds.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation settle
on the food and in the cavity of
the oven.
The display shows "12.00".
18
Before you replace the lamp:
Step 2
Disconnect the oven from the
mains.
Possible cause
The oven is incorrectly connec-
ted to an electrical supply.
The oven is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven for
too long.
There was a power cut.
Step 3
Put a cloth on the bottom of
the cavity.
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connection
diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings are
correct.
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
Replace the lamp.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
Reset the clock.