Trango Systems TrangoLink-10 User Manual page 20

Configuration
Parameter Description
match the RU's RSSI Target setting. The user
does not manually set the RU's transmit power.
RF RX Threshold Specifies the receiver sensitivity of the radio.
This user-changeable parameter is a powerful
tool that is useful for mitigating the effects of
interference. The radio will not process any
signals receieved that are weaker than the RF RX
threshold.
Active Channel Current channel. If MU Autoscan feature is on,
and if the RU is not associated to an MU, it will
continue to cycle through all channels until it
detects and MU.
Broadcast Packet This switch (0) enables/disables the blocking of
Filter Ethernet control packets, except ICMP and ARP,
to reduce the amount of unnecessary overhead
introduced to the wireless link.
MU Autoscan This switch (1) is to turn MU Autoscan on or off.
TCP/IP for MU This switch (2) when on, allows users at the MU
side of the network to telnet or HTTP into the
RU.
Remarks User definable radio information (i.e. customer
name, address of installation, and so on).
Maximum 28 characters can be stored.
Trango Broadband Wireless — TrangoLINK-10 User Manual Rev. E 3.0
Remote Unit System Information
Associated Page and Notes
Advanced page
CLI Command:
rfrxth <ism> <-90|-85|-80|-75|-70|-65>
Informational Parameter
Configuration page
sw 0 [<on | off>]
Configuration page
sw 1 [<on | off>]
Configuration
sw 2 [<on | off>]
Informational Parameter
page
16