ProFlow PF-OXY1 Installation & Operating Instructions Manual page 13

PROGRAMMING INSTRUCTIONS -
CONFIGURATION PARAMETERS

Before entering the programming mode, make sure that
the appliance is in the service mode.

All configuration parameters on this appliance have
been pre-programmed in the factory, to offer optimal
performance in a wide range of applications and situations.
Nevertheless it may be necessary or desirable to change any
of these parameters, to further optimize the appliances
performance or to adapt it to the specific requirements of
the installation.
1. Press the scroll button and hold it for 5 sec until the
display shows:
System Check
2. Within 10 sec, press the up
show:
Cycle 1:
Press the up or down

of the regeneration cycle.
Press the scroll button again to advance to the next

regeneration cycle.
Cycle 1 Backwash
Cycle 2 Air intake
Cycle 3 Fast rinse
Cycle 4 No function (PF-OXY1,5 & PF-OXY1,5
3. Press the scroll button again; the display will show:
Regen @
Press the up or down

regeneration.
4. Press the scroll button again; the display will show:
Exit
Press the up or down

program into the
programming level.
ELECTRONIC CONTROL PANEL
button; the display will
XX min
button to set the length
0:00
button to set the time of
button to save the
NOVRAM® and exit the
+ )
Page 13
EN - English