Table of Contents
Advertisement
Appendix A
Link Control
The Link Control page features the RF Link Loopback / Speed Test. In this test, the user specifies the transmission rate
(in Mbps) in both the local radio and the peer radio as well as the duration time (in minutes) for the test. During the test,
the local radio will transmit packets across the wireless link. The peer radio will retransmit equivalent packets back to
the local radio. The test will measure and report error rate and actual throughput as measured in Mbps. The following
link test was run for 60 seconds with a specified TX rate of 54 Mbps per end.
To run a link loopback test, both radios must be in Opmode ON and status "Connected"
In this example, the error rate was 0 packets from MU to RU and 0 packets from RU to MU. Measured aggregate
bandwidth is 43.39 Mbps.
Trango Broadband Wireless — TrangoLINK-45
page 48
Advertisement
Table of Contents
Need help?
Do you have a question about the TrangoLINK-45TM and is the answer not in the manual?
Questions and answers