insys icom GPRS 5.1 serial Manual page 61

INSYS GPRS 5.1 serial
Alternatively, our example can be set using the terminal program:
In this example, you must note the order of the AT
commands!
Automatic activation of SMS dispatch
AT**INPUT1=1 for input 1; if you want to use only 1
switch input, use input 1.
AT**INPUT2=1 for input 2.
Set SMS storage locations
Activate SMS text mode
Delete SMS storage location 1 preliminary,
AT+CMGD=2 for storage location 2. You must
this storage location, if you want to trigger an SMS via
the second input.
The SMS service center number of the network provider
(may be omitted if the number is stored on the SIM card).
Enter the destination phone number
Wait for the prompt ">", enter the text
The SMS is saved using the key stroke combination
Ctrl+Z.
If you trigger an SMS via input 2, you continue entering
the text for the SMS 2.
With AT+CMGL=ALL, you can check if the messages were
stored correctly and in the correct order.
Save settings for advanced functions
Save settings for SMS commands
Perform RESET, accept all parameters
AT**INPUT1=1
AT**INPUT1=2
AT+CPMS=MT,MT,MT
AT+CMGF=1
AT+CMGD=1
delete AT+CMGD=2
AT+CSCA=<SCNR>
AT+CMGW=<nr>
> <text message
1>
<Ctrl+Z>
OK
AT+CMGW=<nr>
> <text message
2>
<Ctrl+Z>
OK
AT**SAVE
AT&W
AT**RESET
Functions
61