insys icom GPRS 5.1 serial Manual page 45

INSYS GPRS 5.1 serial
Alternatively, the access control can be set using the
terminal program:
Activating selective call acceptance
Deactivating selective call acceptance
Note: The settings are only changed after they were
saved and the device has been reset.
Incoming calls of numbers which are not allowed are
displayed until the caller ends the signalling. They can
neither be accepted manually. The caller receives the
signal BUSY.
For each incoming call, the phone number is
displayed as well.
The released number has to be configured in exactly the
same format as for a call.
Note: The transmitted format of the number depends on
the provider – e.g. the leading "+49" may be
replaced by "0049". We urgently recommend
verifying the number by placing a test call.
It is possible to allow whole blocks of numbers: The wild-
card character „*" replaces exactly any single digit.
Functions
AT**CLIP=1
AT**CLIP=0
AT**SAVE
AT**RESET
ATA
BUSY
RING
+CLIP:
„+49941586920",1
45,,,,0
AT**CLIP1=
+49941586920
AT**CLIP1=
+499415869**
45