Parameter Value Modification; Keyboard Lock; Hot-Key; Upload: Configuration Transfer From Device To Hot-Key - Emerson Dixell XC15CX Installing And Operating Instructions

SET+DOWN buttons. A parameter placed at the level Pr1 will be indicated by switching on the
decimal point toghether with the parameter label.

12.3 PARAMETER VALUE MODIFICATION

The following procedure is valid both for Pr1 and Pr2 levels:
1. Access the required programming menu
2. Select the parameter to modify by using UP or DOWN buttons
3. Press the SET button to display the actual parameter value
4. Change the value by using UP or DOWN buttons
5. Press the SET button to store the new value and move to the next parameter
EXIT: press SET+UP or wait for 30 sec without pressing any key.
NOTE: the new value will be stored even in case the exit from the programming menu is by
timeout.
13.

KEYBOARD LOCK

To prevent any random modification of the operating parameters it is possible to lock the
keypad:

KEY LOCK: keep both UP and DOWN buttons pressed for 3 sec: the message "PoF"
indicates that the keyboard is locked.

UNLOCK THE KEYBOARD: keep both UP and DOWN buttons pressed for 3 sec:
the message "Pon" will indicate that the keyboard is unlocked.
14.

HOT-KEY

By using the HOT-KEY programming tool (Code DK00000100) it is possible to transfer any
configuration to and from the internal memory device.
14.1 UPLOAD: CONFIGURATION TRANSFER FROM DEVICE TO HOT-
KEY
1. Insert an HOT-KEY into the 5-pin port paying attention to the polarity
Press the UP button: the message "uPL" will be displayed during the upload
2.
operation. At the end of the operation the label "End" will blink on the display
Press the SET button and the label "End" will stop flashing
3.
4. Turn off the device and remove the HOT-KEY. After that turn on again the device
NOTE: the "Err" message on the display indicates that the operation is not successful (transfer
error or incorrect key). In this case, press the UP button again to restart the upload operation or
remove the HOT-KEY to abort this operation.
14.2 DOWNLOAD: CONFIGURATION TRANSFER FROM HOT-KEY TO
DEVICE
1. Turn off the device
2. Insert an HOT-KEY on the 5-pin port paying attention to the polarity and then turn on
again the device
3. The list of parameters present into the HOT-KEY memory will be automatically
downloaded into the device memory. The word "doL" will appear during this operation.
At the end of this operation the display will blink the "End" label
4. After 10 sec the device will restart automatically
1592001530 XC15-35CX EN r1.2 11.04.2017 XC15-35CX 18/40