Table of Contents
Advertisement
TL-SL2109
8+1G Gigabit Ethernet Smart Switch User Guide
Fig 4.10 Configuring the Port Status
2.
Every port of the Switch can be configured by the software, as fig 4.11, but you can
not operate the dark button.
Fig 4.11 Configuring the Port Status
There are a few descriptions as follows:
Speed/Duplex: You can select Auto Negotiation or Force Mode, 100Mbps Full Duplex,
100Mbps Half Duplex, 10Mbps Full Duplex, 10Mbps Half Duplex. If you select the Half
Duplex, the port can transfer or receive the packages. But the port can transfer and
receive the packages at the same time of you select the Full Duplex.
If the Auto Negotiation is enabled, the port can select the favoured speed and duplex by
terms of the port connected up far end.
Default Setting: Auto Negotiation
Priority: The priority, is an advanced feature of the switch, makes the important
information transferred firstly come to true. The port-based priority is that you can
configure the priority by terms of the port you selected. The tag-based priority is that the
switch extracts the VLAN tag or the ToS tag from the packages, then make sure the
packages' priority. The switch can only use the port-based priority. It divides two levels —
Low and High.
Default Setting: Port Number (Low)
- 15 -
Advertisement
Table of Contents
