Hang On The Wall; Power On; Initialization - TP-Link TL-SL2109 User Manual

TL-SL2109

3.1.3 Hang on the wall

The TL-SL2109 can be hung on the wall.
1. Drill two holes with a 6mm diameter on the wall, the distance between the holes is
160mm.
2. Press the plastic tube in the hole entirely, then put screws in the plastic tubes, screw
them with a few body stuck out the wall;
3. Place the switch to the two screws by the holes in the switch.

3.1.4 Power on

The TL-SL2109 can be used with the power source in the range of 110 to 260 VAC,
50-60Hz. After the power is on, the power LED will be light.
Caution: As a precaution in the event of a power failure, unplug the switch, when the
power resumed, plug the switch back in.

3.1.5 Initialization

Turn on the power, the switch will automatically initialize and the LEDs, will be light as
follows:
1. As the time you turn on the power, the LEDs will turn on for a second, which indicates
system resetting.
2. The power LED is always light.
8+1G Gigabit Ethernet Smart Switch User Guide
Figure 3-2 Fasten the Switch in the rack
- 6 -