Mitsubishi Electric 700 Series Instruction Manual page 42

Input method of torque command
Torque command may be input in either of the following two ways:
(1) How to set the torque command value when the input signal is 0 and 7FFF
Set the torque command value when the
input signal is "0" in Pr. 447 and the
torque command value when the input
signal is "7FFF (7FF
H
The figure on the right shows the case
when the torque command value is set
using input signal 7FFFH (7FFH) when
the torque command value is 150%
(initial value at Pr. 448). When the most
significant bit of input signal is positive, a
negative torque command value (-150%)
is set also at the same time.
) in Pr. 448.
H
Most significant bit = 1
Torque command value
Pr. 448
150%
7FFF
H
(7FF )
H
0
-150%
PARAMETERS
(7FF )
H H
Initial value
Digital input signal
7FFF
H
Pr. 447
(7FF )
H
Most significant bit = 0
5
37