Installing Controllers - Fujitsu PRIMERGY RX200 S3 Options Manual

Controllers in Non-Hot-Plug PCI Slots
8.1

Installing controllers

Ê Open the server as described in the
Removing the riser card holder
Figure 22: Removing the riser card holder
Ê Grasp the riser card at the two green points labeled with "LIFT UP" and pull
it up and out.
Installing a controller
Ê Please read the documentation supplied with the controller.
Ê Plug any necessary cables onto the controller.
Ê Remove the slot cover from the riser card holder.
I
Keep the slot cover for future use. If you remove the controller, you
must reinstall the slot cover to comply with EMC regulations (regula-
tions on electromagnetic compatibility) and to satisfy cooling require-
ments and fire protection measures.
RX200 S3
chapter "Preparation" on page
Options Guide
Installing controllers
17f.
39