Procedure - Fujitsu PRIMERGY RX200 S3 Options Manual

2

Procedure

V
CAUTION!
The actions described in this manual should only be performed by
engineers, service personnel or technical specialists.
Equipment repairs should only be performed by authorized, qualified
staff.
Any failure to observe the guidelines in this manual, and any unautho-
rized openings and improper repairs could expose the user to risks
(e.g. electric shock, fire hazards) and could also damage the
equipment.
Please note that any unauthorized opening of the device will result in
the invalidation of the warranty and exclusion from all liability.
Ê First of all please familiarize yourself with the safety instructions in the
chapter "Safety Instructions" on page
Ê Make sure that all required manuals (see
the server" on page
You will definitely need
– the Operating Manual for the server and
– the Service Supplement for the server
– the Technical Manual for the system board.
Ê Shut down the server correctly, switch it off, pull out the power plug, and
open the server as described in the
Ê Extend or upgrade your server as described in the relevant chapter.
I
How to install/remove the hot-plug components is described in the
Operating Manual for the server.
Ê Close the server, plug all mains plugs into the power outlets, and switch on
the server as described in the
Ê Start the operating system and, if necessary, configure it as required (see
the Operating Manual).
RX200 S3
5) are available, printing out the PDF files if necessary.
chapter "Preparation" on page
chapter "Completion" on page
Options Guide
11ff.
"Additional documentation about
17ff.
41ff.
9