Makita BO6050 Technical Information page 28

W
iring diagram
Fig. D-7
Insulated terminal
Fig. D-8
Put Lead wire (blue)
or (white) of Power
supply cord under
this rib.
Terminal block
Put the following Lead
wires connected to
Switch, to this space.
* Field lead wire (white)
* Controller's lead wire
(blue) or (white)
* Noise suppressor's Lead
wire (black)
Put the lead wire (clear) to
the same space, in case that
Noise suppressor with
grounding lead wire is used.
Put "Lead wires (clear)" of
Noise suppressor to this
Lead wire holder, if Noise
suppressor with grounding
lead wire is used.
Push Grounding terminal
(if used) deep into this
hole, until it stops.
Wiring to Switch
Stepped side flat side
Switch
Tumbler
Wiring on Motor housing
Head cover set R side view
Connect Insulated terminal to Switch
as follows.
* Facing its flat side to Switch
* Facing lead wire connected portion to
Tumbler side
Wire connected portion
Pay attention not to
put any lead wires
on this rib.
Pass the following Lead
wires connected to Switch
through this space.
* Field lead wire (white)
* Controller's lead wire
* Noise suppressor's Lead
Power supply cord
Put Lead wires (blue),
(brown) of Power supply
cord under this rib.
Switch
Head cover set R
(blue) or (white)
wire (black)
P 28 / 28