Epson CW-C6000 Series Technical Reference Manual page 62

6
Perform jumper settings. Pull out the connector jumper pin and insert it into the
number to be set.
Press with your fingers on the right side of the interface board to affix it while pulling and inserting
the jumper pin.
c
IMPORTANT
Power supply/SG not separated (Initial setting)
Power supply/SG separated
Once jumper settings are performed, install the covers using the following procedure.
7
Install the internal cover and affix it using the screws (x 4).
8
Install the left side cover and affix it using the screws (x 5).
62
• When shorting pins 1 and 2 on CN100, DO NOT short pins 2 and 3 on CN200.
• When shorting pins 2 and 3 on CN100, DO NOT short pins 1 and 2 on CN200.
State
Jumper pin
CN100 CN200
CN100 JP setting CN200 JP setting
1-2 pin shorted 1-2 pin shorted
2-3 pin shorted 2-3 pin shorted