Flybar Spark Manual page 8

11 10
Repeat Step 5 and Form a Circle
STEP 3: Prepare the FRAME SEGMENTs
Pick up a FRAME JOINER and a FRAME TUBE, and then insert the larger square end
of the FRAME TUBE into the square tube of the FRAME JOINER to form a FRAME
SEGMENT. Please make sure the holes of the FRAME TUBE are facing upward before
you insert it into the FRAME JOINER. Please be aware the round tubes of the FRAME
JOINER should be vertical to the surface and facing outward.
Repeat this process, and prepare all FRAME SEGMENTs.
STEP 4: Join the FRAME SEGMENTs and form a circle
STEP 6: Prepare and align Safety Net Door
Make sure the Safety Net door is in the middle of two Frame Joiners
Pick up two FRAME SEGMENTs and Insert the small square end (without the FRAME
JOINER) of one FRAME SEGMENT into the larger square end (with the FRAME
11 10
JOINER) of the other FRAME SEGMENT.
*If you have any problems by this stage, please do not try to install the trampoline and call 1300 782 661
Version 1.0
9 8
Before forming a full circle, it may be hard to fully insert the
last frame tube into the frame joiner, but don't worry just
make sure they are attached as the strength of the springs
will pull them together in Step 7
Frame Tube
Frame Segment
12
H
G
9 8
F
E
Frame Segment 1
D
C
B
A
7 6
Frame Joiner
11 10
7 6
Fr a me
J oiner
Frame Segment 2
Distributed by:
7
5 4
9 8
UNLESS OTHERWISE SPECIFIED: FINISH:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR:
ANGULAR:
NAME SIGNATURE DATE
DRAWN
CHK'D
APPV'D
MFG
MATERIAL:
Q.A
WEIGHT:
5 4
S afety Net Door
Fr ame
J oiner
Ellenville, NY 12428
Email: spark@flybar.com
Web: www.flybar.com
3 2
7 6
DEBURR AND
DO NOT SCALE DRAWING
BREAK SHARP
EDGES
TITLE:
DWG NO.
N-ASSM_A1 -
SCALE:1:20 SHEET 1
3 2
6
Ph: 845-647-8400