Beko WRS 5511 BWW User Manual page 15

To deactivate the Child Lock:
Press and hold Speed and Delayed Start buttons for 3 seconds while any programme is running. While
you are holding for 3 seconds, the "Child Lock Enabled LED" will flash. You can release the buttons
when the LED turns off completely.
In addition to the method above, to deactivate the Child Lock, switch the Programme
Selection knob to On / Off position when no programme is running, and select another
programme.
Child Lock is not deactivated after power failures or when the machine is unplugged.
4.12 Progress of programme
Progress of a running programme can be followed from the Programme Follow-up indicator. At
the beginning of every programme step, the relevant indicator light will turn on and light of the
completed step will turn off. You can change the speed settings without stopping the programme flow
while the programme is running. To do this, the change you are going to make must be in a step after
the running programme step. If the change is not compatible, relevant lights will flash for 3 times.
If the machine does not proceed to the spinning step, the Rinse Hold function might be
active or the automatic unbalanced load detection system might be activated due to the
unbalanced distribution of the laundry in the machine.
4.13 Loading door lock
There is a locking system on the loading door of the machine that prevents opening of the loading
door in cases when the water level is unsuitable. Loading door light will start flashing when the
machine is switched to Pause mode. The machine checks the level of the water inside. If the level is
suitable, the Loading Door light turns off and the loading door can be opened within 1-2 minutes. If
the level is unsuitable, the Loading Door light remains on and the loading door cannot be opened.
If you are obliged to open the Loading Door while the Loading Door light is on, you must cancel the
current programme. See. "Cancelling the programme"
4.14 Changing the selections after programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the machine to pause mode while a programme is running.
The light of the step which the machine is in starts flashing in the Programme Follow-up indicator to
show that the machine has been switched to the pause mode. Additionally, when the loading door is
openable, the Loading Door light turns off completely.
Changing the speed settings
You can change the speed settings of the programme that is currently running. See "Speed selection".
If no change is allowed, the relevant light will flash 3 times.
Adding or taking out laundry
1. Press Start / Pause button to switch the machine to pause mode. The programme follow-up light of
the relevant step during which the machine was switched into the pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out the laundry.
4. Close the Loading Door.
5. Make changes in speed settings, if necessary.
6. Press Start / Pause button to start the machine.
4.15 Cancelling the programme
To cancel the programme, turn the Programme Selection knob to select another programme. Previous
programme will be cancelled. End / Cancel light will flash continuously to notify that the programme
has been canceled. Your machine will end the programme when you turn the Programme Selection
knob; however, it does not drain the water inside. When you select and start a new programme, the
newly selected programme will start depending on the step the previous programme was canceled in.
For example, it may take in additional water or continue to wash with the water inside.
Some programmes may start by discharging the water inside the machine. Depending
on the step where the programme was canceled in, you may have to put detergent and
softener again for the programme you have selected anew.
15 / EN
Washing Machine / User's Manual