Toshiba RAV-RM561FT-EN Service Manual page 70

[3] Writing the setting data to EEPROM
(Stop the operation of the unit.)
1
Push the [ MENU] button to display the menu screen.
2
Push and hold the [
"Field setting menu".
• Push and hold the buttons for more than 4 seconds.
3
Push the [
screen, then push the "
• When the group control is used, all the indoor units connected into the system are displayed on the screen.
4
Push the "
Unit
setting data to EEPROM, then push the "
• The setting display for the selected unit is displayed.
• The fan and louver of the indoor unit operate.
5
Move the cursor to select "Code (DN)" with the "
"[0010]" with the [
6
Move the cursor to select "Data" with the "
[ ] / [
type, set "Data" to [0013].
7
Push the [ MENU] button to set the other "Code(DN)" and "Data". After "Continue?" is
displayed on the screen, push the "
8
Move the cursor to select "Code(DN)" with the "
with the [
9
Move the cursor to select "Data" with the "
[ ] / [
For RM56 model, set "Data" to [0009].
10
Push the [
displayed on the screen, push the "
operation. " Setting" is displayed on the screen for a while, then the screen returns to the "Field
setting menu" screen.
11
Pushing the [
screen for a while when the single operation is used, then the screen returns to the "Field
setting menu" screen.
(It takes approx. 1 min until the remote controller operation is available again.)
12
Write the on-site setting data, such as an address setting, after installation to the EEPROM.
Perform the operation of
13
Push the "
[ ] / [
(Filter sign lighting time)
14
Check the setting data displayed at this time with the setting data written down in [1] Setting
data read out from EEPROM.
If the setting data is different, set "Code(DN)" with the [
" >" [
>
[1] Setting data read out from EEPROM with the [
[ MENU] button.
If the setting data is the same, proceed to next operation.
MENU] button and the [
] / [ ] button to select "7. DN setting" on the "Field setting menu"
Set" [
Set
unit" [ F1] button to select indoor unit in which you want to write the
F1
] / [
] button to set the "Data" to each Type name of indoor unit. For Floor standing
] / [ ] button.
] button to set the "Data" to each capacity of indoor unit.
MENU] button to set the other "Code(DN)" and "Data". After "Continue?" is
CANCEL] button on the unit selection screen displays "
1 4
to again.
<" [ F1] button to select "Code(DN)", then set it to [0001] with the
<
F1
] button.
F2] button to select "Data" and change it to the setting data written down in
F2
] button at the same time to display the
F2] button.
F2
Set" [
Set
<
] button.
>" [
>
Yes" [
F1
Yes
<
>" [
>
No" [
F2
No
] / [
– 70 –
F2] button.
F2
<" [ F1] button, then set
F1
F2] button, then push the
F2
F1] button.
<" [ F1] button, then set [0011]
F1
F2] button then push the
F2
F2] button to finish the setting
Setting" on the
] / [ ] button, push the
] button, then push the