Component Identification - Graco InvisiPac GM100 Plug-Free Instructions Manual

Component Identification

Component Identification
Slim model shown on the left. Dual Low Profile model shown on the right.
F . 1: Hot Melt Applicator Component Identification
IG
Key:
A Module
B Fluid Outlet
C Fluid Filter
D Manifold
E Fluid Inlet (9/16-18, -6 JIC, 37° flare)
F Cordset*
G Air tubes
* Cordset is an exposed bare metal conduit on all
applicator models except for 25B021 and 25B024.
The applicator cordsets for 25B021 and 25B024 have
a black rubberized coating over the metal conduit.
6
H Mounting Clamp (1/2 in, diameter bar)
J Solenoid valve (24 VDC)
L Air inlet (1/4 in. diameter tubing)
M Manual override switch
N M8 Solenoid valve electrical connector
O Air close exhaust port
P Air open exhaust port
334627K