Advertisement
Quick Links
Table of Contents
What to Expect with
Your Installation
7 feet
Ceiling Bracket
Blades
Tools Needed
30 inches
Ladder
2
Downrod
6
Switch Housing
12
M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company
Preparation
3
Wiring
7
Wall Control
14
1
www.CasablancaFanCo.com
Mounting Options
4
Canopy
10
Troubleshooting
?
?
?
?
15
1.888.227.2178
5
11
?
20
Advertisement
Related Manuals for Casablanca 55082
Summary of Contents for Casablanca 55082
- Page 1 Table of Contents www.CasablancaFanCo.com 1.888.227.2178 What to Expect with Your Installation Tools Needed Mounting Options Preparation 30 inches 7 feet Ladder Ceiling Bracket Downrod Wiring Canopy Blades Switch Housing Troubleshooting Wall Control M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 2 Assess ceiling angle Select a downrod length installed and used in accordance with the instructions may cause harmful interference to radio communications. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 3 9/64” Drill Bit bag. The symbols can be used Screwdrivers (optional) (optional) to identify the appropriate If mounting to a support structure, you hardware for each step. will also need these tools. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 4 Save the screws. They will be next couple of steps. needed for blade iron installation. Note: Some fans will have a shipping ring instead of shipping blocks. Please remove the ring and save the screws. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 5 You need ONLY You need BOTH a Longer a Longer Downrod Downrod & an Angled Mounting Kit *most common M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 6 To avoid possible electrical shock, before 1-888-277-2178. installing your fan, disconnect the power by turning off the circuit breakers to the outlet Refer to warning w.1 on pg. 2 box associated with the wall switch location. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 7 Steps 1-5 to remove standard downrod pipe Longer Downrod for angled ceilings or ceilings 10’ or higher Shorter Downrod for fans installed close to ceiling Steps 6-10 to reassemble with new pipe M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 8 4-5 full turns) until it stops. with pliers. DO NOT can be inserted. from the top of the downrod. HAND TIGHTEN. 8” 3/8” If the setscrew is not tightened securely, the fan may fall. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 9 Put the wires and downrod through the canopy. Let the canopy sit loosely on top of the fan. CANOPY OR WIRES. Place the downrod ball into the slot in the ceiling bracket. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 10 70. If you are unfamiliar with wiring or in into the outlet box. Make sure that the wires are still attached to the wire nuts. doubt, consult a qualified electrician. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 11 Insert the two canopy screws lifted into place, the canopy fits into the screw holes are aligned. found in the hardware bag. the hanging bracket as shown. Note: Fan style may vary. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 12 M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 13 Make sure the upper switch housing is securely attached to the mounting plate. Failure to properly secure all 3 assembly screws could result in the switch housing fixture falling. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 14 Failure brushes or cloths to prevent to properly secure all 3 assembly screws could scratching. Cleaning products result in the switch housing fixture falling. may damage the finishes. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 15 This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 16 Reference the included remote function card Installing the Wall Plate for information on how to use your wall control! Push the wall plate onto the Wall Plate Bracket. It should snap into place. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 17 Wall Control For Dual Switches www.CasablancaFanCo.com 1.888.227.2178 To install the Casablanca Wall Control into a dual switch location, Verify which switch controls the fan light. you will need a wall plate with both a standard switch and rocker Turn on power for the fan.
- Page 18 Reference the included remote function card provided wire nuts. for information on how to use your wall control! Push all wires into the switch box. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 19 Long Long Light High Fan High Press Press Long Long Light Low Fan Low Press Press Long Dimming Mode Long Press On/Off Fan Reverse Press Power On/Off Long Pair Function Press M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 20 If applicable, the blades are cracked. If so, replace fan will turn on and the lights all of the blades. will flash and stay on to indicate successful pairing. M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...
- Page 21 If applicable, the fan will turn off and the lights will flash turn on and the lights will flash and stay on to indicate successful pairing. and turn off to indicate successful “unpairing.” M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company...