Advertisement
Wall Control For Single Switch
If you have a dual switch setup, go to page 18
for dual switch installation instructions.
1
Turning off the power
Ensure the power is OFF at the outlet
box and wall switch location before
proceeding with installation.
2
Installing the battery
To access the battery compartment,
slide the battery door up.
Replace the used battery with two AAA
batteries when needed.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
OFF
Battery
Door
15
M8551-01 • 09/25/18 • © 2018 Casablanca Fan Company
www.CasablancaFanCo.com
3
Installing the Wall Plate Bracket
Snap the Wall Control into the
Wall Plate Bracket.
4
Wiring the Wall Control
1.
Connect the grounding wire
from the wall control to the
ground control from the switch
box using the provided wire
nuts.
2.
Connect the "LIVE IN" from
the switch box to the "~VAC"
from the wall control using the
provided wire nuts.
3.
Connect the "LIVE OUT" from
the switch box to the "FAN" out
from the wall control using the
provided wire nuts.
4.
Push all wires into the switch
box.
1.888.227.2178
Advertisement
